Dumb RGB Expansion Board
Add three channels to your RF1 12v
This board was built to make use of the PWM channels on the RF1_12v
Power the board with 12V up to 6 amps and the RGB Expansion board will drive them.
The header on the Dumb RGB expansion board is fully compatible witht the RF1_12V, It is also possible to connect the expansion board to an existing board which is controlling pixels.
Comes with a 3amp fuse, Mosfets, Resistors and 15 + 1 header pins. Does not include pins for the +12v, R, G, B header.
RF1 control board not included.
*The MOSFETs used on the dumb rgb expansion board will not work with the 5v rf1 board. The 5v board utilizes a 3.3v regulator which is insufficient for the gate voltage. It may be possible to use logic level MOSFETs with the rf1 5v.
Schematic:
PDF
Eagle Files:
Zip
Wiki - Hardware Guide:
http://learn.komby.com/wiki/14/rf1_12v-assembly-instructions
