RF1 Header - LED Test board(PCB Only)

RF1 Header with lots of blink possibilities!
Availability: 3 in stock
Ship to
Shipping Method
Estimated Delivery
No shipping options

The RF1 LED Test board was built to help quickly make sure your RF1 got put together correctly.   It's small, and a great warm up project for those wanting to try some SMD Soldering.


Board has 13 0603 LED's on board  so be prepared to squint!   

also uses 0805 Resistors, so the only through hole components are the header pins.

Good for debugging too!


*Included in Package

1 LED Test board PCB only.


to build this board you will need

1 15 pin male or female pin header

13 0805 220Ohm resistors

and 13 0603 LEDs of your color choice.

Customers who bought this item also bought

Reset Breakout

Common TTL Serial to RF1/WM2999 controller compatible header.

nRF24L01+ 2.4 GHz RF - Zig Zag Antenna Black Zig-Zag Transceiver

The Nordic nRF24L01+ is a highly integrated, ultra low power (ULP) 2Mbps RF transceiver IC for the 2.4GHz ISM (Industrial, Scientific and Medical) band. With peak RX/TX currents lower than 14mA, a sub μA power down mode, advanced power management, and a 1.9 to 3.6V supply range, the nRF24L01+ provides a true ULP solution enabling months to years of battery life from coin cell or AA/AAA batteries. The Enhanced ShockBurst™ hardware protocol accelerator offloads time critical protocol functions from the application microcontroller enabling the implementation of advanced and robust wireless connectivity with low cost 3rd-party microcontrollers.

RF1 Dumb RGB Expansion board Rev2 (Board + BOM)

The Dumb RGB Expansion board adds 3 Mosfet / PWM control to your RF1_12v so you can easily control 12V RGB strips!